They spent an hour with everyone in the room listening in as I presented my career.
Then I went from one interviewer to another and each spent an hour quizzing me on technical subjects.
After 4 hours it felt more like an SAT test than an interview as I was rushed from one person to the next.
It was then that I realized that nobody had asked if I had any questions or even said a word about the position.
Was it stress or design?
Ground support or flight?
Florida or Washington?
They supposedly don't have "formal titles" so it seemed like everyone just kinda goes around and does whatever.
When the recruiter found out I wasn't interested in Washington State, we parted ways.
It was definitely for the best, because it was obvious that the company is pretty far behind the bell curve.
I wasn't impressed with any of the interviewers, and the hiring manager had only been with the company for 2 months.
Their attitude is clearly "You're here to try and prove yourself to us" rather than a 2 way conversation to see if both the individual is a good fit for the company and the company is a good fit for the individual.
Sketch the shear and moment diagrams for a pinned, pinned beam with a distributed load, draw a typical stress strain curve and label the parameters, draw bearing bypass loads on a composite plate, draw a freebody diagram of a fastener holding two plates together and discuss what you would check, what is top down design, how would you design this fin, etc...too many more to list.
The following metrics were computed from 5 interview experiences for the Blue Origin Engineer role in Kent, Washington.
Blue Origin's interview process for their Engineer roles in Kent, Washington is fairly selective, failing a large portion of engineers who go through it.
Candidates reported having very negative feelings for Blue Origin's Engineer interview process in Kent, Washington.